Overhaul dan Uji Performansi Generator Firman FPG1510 RV1-C
Abstract
Electrical energy is one of the essential needs for garment entrepreneurs in Cileungsi, Bogor Regency, West Java, to support their production activities. However, frequent power outages in the region often disrupt the production process. The Firman FPG1510 RV1-C generator set (genset) can serve as a solution to overcome these outages, but the unit was found to be inoperable after initial evaluation. An overhaul maintenance was performed after component-level servicing failed to restore stable operation. The results of the overhaul process were evaluated through performance testing, which included fuel consumption testing under a 570Watt electrical load and exhaust emission measurements. The performance test results show that the highest fuel consumption rate (ṁbb) was 0.000089 kg/s at 3177 RPM. At the same speed, the highest brake specific fuel consumption (BSFC) was recorded at 0.21456 kg/kWh. The maximum electrical efficiency (ηt) was achieved at 3006 RPM with a value of 17.35%, while the highest brake thermal efficiency (BTE) was 43.45% at 2973 RPM. The emission test after overhaul produced CO levels of 0.92–2.72% and HC levels of 80–153 ppm, both of which comply with the Bandung City emission standards for gasoline engines (CO 4.5% and HC 1200 ppm). A comparison between the post-overhaul performance and the manufacturer’s specifications shows that the indicator shaft power after overhaul reached 1.42 kW at 3006 RPM, compared to 1.17 kW at 3000 RPM in the standard specification. This indicates a 21% increase in shaft power as a result of the overhaul maintenance.
Full Text:
PDFReferences
D. R. Pamungkas, W. . Bhirawa, and B. Arianto, “Analisa Performansi Pemeliharaan Generator Set (Genset) dengan Metode TPM (Total Productive Maintanance) untuk Meningkatkan Kerja di PT. Lativi Media Karya,” J. Teknol. dan Manaj. Ind. Ter. Ind., vol. 8, no. 1, p. 5, 2019.
R. L. S. Ira Destiana Pasaribu, “Analisis Pengaruh Pemadaman Listrik Secara Berkala Serta Penggunaan Genset Terhadap Kegiatan Usaha Mikro Di Kecamatam Medan Baru,” J. Ekon. dan Keuang., pp. 500–512, 2014.
D. W. Syahputra and S. Wahyuningsih, “Analisis Gangguan dan Perawatan pada Mesin Diesel generator di KM. Egon,” J. Bus. Technol. Econ., vol. 1, no. 1, pp. 1–7, 2023.
Y. Huang et al., “Impact of drivers on real-driving fuel consumption and emissions performance,” Sci. Total Environ., vol. 798, 2021, doi: 10.1016/j.scitotenv.2021.149297.
S. B. Nugroho, A. Fujiwara, and J. Zhang, “Analysis of Inspection and Maintenance Program in JABODETABEK Indonesia Nugroho, S.B., A. FUJIWARA, Junyi ZHANG Transportation Engineering Laboratory, Graduate School for International Development and Cooperation, Hiroshima University Japan,” 12th World Conf. Transp. Res., pp. 1–14, 2010.
D. Aldyansyah et al., “Perawatan Mesin Alat Berat Wheel Loader PT. XYZ,” J. Tek. Mesin, vol. 20, no. 1, pp. 18–23, 2023, doi: 10.9744/jtm.20.1.18-23.
R. Antema, S. Samsuddin, and I. Zein, “Analisa Perawatan Mesin Genset pada Perusahaan Penyedia Layanan Telekomunikasi dengan Menggunakan Metode RCM,” Juni, vol. 2, no. 2, pp. 1–7, 2022.
Didik Wahjudi and Amelia Amelia, “Analisa Penjadwalan Dan Biaya Perawatan Mesin Press Untuk Pembentukan Kampas Rem,” J. Tek. Mesin, vol. 2, no. 1, pp. 50–61, 2000.
I. D. Pranowo, Sistem dan Manajemen Pemeliharaan Maintenance: (System and Management). Yogyakarta: DEEPUBLISH (CV BUDI UTAMA), 2019.
R. A. Trianbowo, “Analisis Jadwal Perawatan Mesin Genset Di Cv. Sejati Teknik Semarang Dengan Metode Reliability Centered Maintenance (Rcm),” J. Tek. Ind., pp. 1–120, 2023.
R. Nurcahyo, D. W. Maulida, D. A. Susanto, and E. Kristiningrum, “Assessment of Maintenance Performance Using the Maintenance Scorecard Method and Prioritization of Problem Control Strategies with the USG Method,” Int. J. Adv. Sci. Eng. Inf. Technol., vol. 13, no. 6, pp. 2267–2273, 2023, doi: 10.18517/ijaseit.13.6.18563.
Y. Effendi, A. Rosyidin, and B. Setiawan, “Peningkatan Performa Termal Dengan Menggunakan Vortex Generators Didalam Saluran Persegi Panjang Vortex generators ( VGs ) are an effective method for improving the thermal performance of heat exchangers . This study aims to optimize the heat transfer rat,” vol. 13, no. 1, pp. 117–126, 2024.
A. Lazzaretto and A. Toffolo, “Prediction of performance and emissions of a two-shaft gas turbine from experimental data,” Appl. Therm. Eng., vol. 28, no. 17–18, pp. 2405–2415, 2008, doi: 10.1016/j.applthermaleng.2008.01.021.
D. H. Qi, H. Chen, R. D. Matthews, and Y. Z. Bian, “Combustion and emission characteristics of ethanol-biodiesel-water micro-emulsions used in a direct injection compression ignition engine,” Fuel, vol. 89, no. 5, pp. 958–964, 2010, doi: 10.1016/j.fuel.2009.06.029.
A. E. Saputra and I. W. Susila, “Uji Performa Mesin Sepeda Motor Honda Beat 108CC Berbahan Bakar Campuran Premium Dan Bioetanol Dari Batang Rumput Gajah,” J. Pendidik. Tek. Mesin, vol. 10, no. 01, pp. 80–86, 2020.
I. Prasetyo, S. Sarjito, and M. Effendy, “Analisa Performa Mesin Dan Kadar Emisi Gas Buang Kendaraan Bermotor Dengan Memanfaatkan Bioetanol Dari Bahan Baku Singkong Sebagai Bahan Bakar Alternatif Campuran Pertalite,” Media Mesin Maj. Tek. Mesin, vol. 19, no. 2, pp. 43–54, 2019, doi: 10.23917/mesin.v19i2.5698.
A. M. Cahya Negara, I. Sigit Atmanto, J. Mrihardjono, S. V. Rekayasa, and P. Mekanik, “Uji Performa Mesin Menggunakan Bahan Bakar Pertamax Dan Pertamax Turbo Pada Mesin 4 Langkah,” J. Mekanova Mek. Inov. dan Teknol., vol. 9, no. 1, 2023.
B. A. Syahar, “Studi Eksperimental Pengaruh Penambahan Gas HHO Pada Pertamax dan E85 Terhadap Unjuk Kerja dan Emisi Gas Buang Motor Honda All New Megapro 150 Cc,” 2018.
Y. Jiang et al., “Understanding elevated real-world NOx emissions: ‘Heavy-duty diesel’ engine certification testing versus in-use vehicle testing,” Fuel, vol. 307, no. August 2021, p. 121771, 2022, doi: 10.1016/j.fuel.2021.121771.
E. Tumembow, M. N., & Dosoputranto, “Teknik Perawatan Perbaikan Mesin,” Angew. Chemie Int. Ed. 6(11), 951–952., p. 297, 1967.
D. Teguh Santoso, Tabah Priangkoso, “Pengujian Performance Mesin Motor Bensin 4 Tak 113 Cc Untuk Penggerak Generator Ac 2 , 5 Kw,” pp. 9–12, 2009.
A. Siagian and M. Silaban, “Performa dan Karakteristik Emisi Gas Buang Mesin Diesel Berbahan Bakar Ganda,” J. Tek. Mesin, vol. 13, no. 1, pp. 49–54, 2011, doi: 10.9744/jtm.13.1.49-54.
DOI: https://doi.org/10.35308/jmkn.v12i1.15186
Refbacks
- There are currently no refbacks.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
p-ISSN: 2477-5029 I e-ISSN: 2502-0498 I DOI: 10.35308
Jl. Alue Peunyareng, Ujong Tanoh Darat, Meureubo, Kabupaten Aceh Barat, Aceh 23681, Indonesia
is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License