Kajian Komparasi Pemeliharaan Rutin Jalan pada Perspektif Kinerja dan Biaya (Studi Komparasi Metode P/KRMS dan PCI Pemeliharaan Rutin Jalan pada UPT Jalan dan Jembatan Wilayah II)

Muhammad Said, Lambang Basri Said, Mukhtar Thahir Syarkawi

Abstract


Tujuan penelitian ini yakni mengkaji jenis tingkat kerusakan yang terjadi di ruas jalan Rantepao-Sa’dan-Batusitanduk Dinas Pekerjaan Umum dan Tata Ruang Provinsi Sulawesi Selatan; Mengkaji pemeliharaan rutin jalan dengan nilai tingkat kerusakan berdasar pada metode Pavement Condition Index (PCI), dan metode P/KRMS; serta Komparasi kedua metode kaitannya dengan Kinerja dan Biaya. Penelitian dilakukan dengan mencari data primer dengan mengukur luasan masing-masing kerusakan dengan menggunakan alat ukur/ mistar melalui survey kondisi pada ruas jalan yang menjadi obyek penelitian di lapangan. Sementara data sekunder diperoleh dari Dinas Pekerjaan Umum dan Tata Ruang Propinsi Sulawesi Selatan berupa peta lokasi ruas jalan yang menjadi obyek penelitian, daftar ruas jalan, rencana startegis Dinas Pekerjaan Umum dan Tata Ruang Provinsi Sulawesi Selatan dan data-data pendukung lainnya. Berdasarkan hasil penelitian dapat diketahui bahwa tingkat Kerusakan atau kondisi kemantapan jalan pada ruas Rantepao-Sa'dan-Batusitanduk berada pada kondisi yang sangat baik karena persentase kerusakan 6,57%; Minimnya kerusakan yang terjadi pada ruas Rantepao-Sa'dan-Batusitanduk terlihat pada hasil survey menggunakan metode PCI dan P/KRMS yang menunjukkan nilai PCI 91,36 (exelent) dan Nilai TTI P/KRMS 0 – 20 (baik) dimana hal tersebut menunjukkan kondisi yang sama dan hanya membutuhkan pemeliharaan rutin. Metode P/KRMS lebih efektif dan efisien karena P/KRMS memiliki perhitungan lebih detail, prioritas penanganan, dan kategori (responsive dan cyclic) dari metode PCI yang hanya berdasarkan perhitungan manual dengan tahun-tahun sebelumnya.

 

The purpose of this study is to examine the type of damage that occurred on the Rantepao-Sa'dan-Batusitanduk road at the Public Works and Spatial Planning Office of South Sulawesi Province, Assessing routine road maintenance with damage level values based on the Pavement Condition Index (PCI) method, and the P/KRMS method; and Comparison of the two ways about Performance and Cost. The research was carried out by searching for primary data by measuring the extent of each damage using measuring devices/rulers through condition surveys on the road sections, which were the object of research in the field. While secondary data was obtained from the Public Works and Spatial Planning Office of South Sulawesi Province in the form of a map of the location of the road sections that were the object of research, a list of road segments, the strategic plan of the South Sulawesi Provincial Public Works and Spatial Planning Office and other supporting data. Based on the research results, it can be seen that the level of damage or road stability on the Rantepao-Sa'dan-Batusitanduk section is in excellent condition because the percentage of damage is 6.57%; The minimal damage that occurred on the Rantepao-Sa'dan-Batusitanduk section can be seen in the results of a survey using the PCI and P/KRMS methods which showed a PCI value of 91.36 (excellent) and a TTI P/KRMS value of 0 – 20 (good) which shows conditions and only requires routine maintenance. The P/KRMS method is more effective and efficient because P/KRMS has more detailed calculations, handling priorities, and categories (responsive and cyclic) than the PCI method, which is only based on manual estimates from previous years.


References


B. Jang and J. Mohammadi, “Bridge rating modification to incorporate fatigue damage from truck overloads,” Bridg. Struct., vol. 13, no. 2–3, pp. 101–107, 2017.

P. Liu et al., “Fatigue Analysis of Long-Span Steel Truss Arched Bridge Part II: Fatigue Life Assessment of Suspenders Subjected to Dynamic Overloaded Moving Vehicles,” Metals (Basel)., vol. 12, no. 6, p. 1035, 2022.

J. Zhang, H. Peng, and C. S. Cai, “Field study of overload behavior of an existing reinforced concrete bridge under simulated vehicle loads,” J. Bridg. Eng., vol. 16, no. 2, pp. 226–237, 2011.

L. Deng, W. Yan, and L. Nie, “A simple corrosion fatigue design method for bridges considering the coupled corrosion-overloading effect,” Eng. Struct., vol. 178, pp. 309–317, 2019.

L. Deng and W. Yan, “Vehicle weight limits and overload permit checking considering the cumulative fatigue damage of bridges,” J. Bridg. Eng., vol. 23, no. 7, p. 4018045, 2018.

A. P. Sari and E. D. Retnani, “Penerapan Balanced Scorecard Sebagai Alat Pengukuran Kinerja Pada Rumah Sakit Islam Surabaya,” J. Ilmu Dan Ris. Akunt., vol. 4, no. 11, 2015.

D. Efendi, E. Hidayah, and A. Hasanuddin, “Mapping of Landslide Susceptible Zones by Using Frequency Ratios at Bluncong Subwatershed, Bondowoso Regency,” 2020.

A. N. Ede, “Cumulative damage effects of truck overloads on nigerian road pavement,” Int. J. Civ. Environ. Eng. IJCEE-IJENS, vol. 14, no. 01, pp. 21–26, 2014.

A. C. N. Widjanarko and N. Handayani, “Pengukuran Kinerja Dinas Pekerjaan Umum Bina Marga dan Pematusan Kota Surabaya Dalam Perspektif Value For Money,” J. Ilmu dan Ris. Akunt., vol. 7, no. 4, 2018.

R. L. Jannah, H. Yermadona, and S. Dewi, “Analisis Kerusakan Perkerasan Jalan Dengan Metoda Bina Marga Dan Pavement Condition Index (PCI)(Studi kasus: Jl. Lintas Sumatera Km 203-213),” Ensiklopedia Res. Community Serv. Rev., vol. 1, no. 2, pp. 114–122, 2022.

F. Wahyudi, “Analisa Kerusakan Perkerasan Jalan Menurut Metode Bina Marga Dan Pci (Pavement Condition Index) Serta Alternatif Penanganannya (Studi Kasus Ruas Jalan Kota Bangun–Gusik),” Kurva Mhs., vol. 1, no. 1, pp. 181–195, 2019.

M. R. Samaiyo, S. M. Hapram, and M. T. Syarkawi, “Kajian Efektivitas Penggunaan Biaya Pada Penanganan Preservasi Jalan Pada Ruas Yetti Senggi Memvrano Kabupaten Keerom Provinsi Papua,” JIM J. Ilm. Mhs. Pendidik. Sej., vol. 8, no. 3, pp. 2892–2899, 2023.

N. A. Munggarani and A. Wibowo, “Kajian faktor-faktor penyebab kerusakan dini perkerasan jalan lentur dan pengaruhnya terhadap biaya penanganan,” J. Infrastruktur, vol. 3, no. 1, pp. 9–18, 2017.

M. Fattah, T. N. Utami, C. A. Intyas, and A. I. Maulidah, “Analyzing the development of Payangan Beach mangrove ecotourism in Indonesia,” Aquac. Aquarium, Conserv. Legis., vol. 15, no. 4, pp. 1926–1937, 2022.

K. Y. Prahastyo, N. Sebayang, and L. K. Wulandari, “Application of Analytic Hierarchy Process Method in Determining The Priority Weights of Road Pavement Planning Criteria On The Project Preservation of Reconstruction of The Road Sidoarjo Pandaan Purwosari-Malang Kepanjen,” Int. J. Sci. Technol. Res., vol. 9, no. 12, pp. 212–221, 2020.

A. Supriyadi, N. M. Wibowo, and S. Subijanto, “Analisis Pengaruh Komunikasi, Pengalaman Kerja Dan Kemampuan Kerja Terhadap Profesionalisme Karyawan Pada Bank Sarana Prima Mandiri Pamekasan,” Ekon. J. Ilm. Manajemen, Ekon. Bisnis, Kewirausahaan, vol. 8, no. 2, pp. 42–53, 2021.

R. M. Fikri and J. Sekarsari, “Analisis Estimasi Biaya Proyek Peningkatan Jalan Beton Di kabupaten Tangerang Dengan Metode Cost Significant Model,” 2015.

A. Yunus, L. B. Said, and A. Alifuddin, “Analisis Penentuan Penanganan Jalan Nasional Metode International Roughness Index (IRI) dan Pavement Condition Index (PCI): Studi Kasus: Ruas Jalan Kalukku-Bts Kota Mamuju,” J. Konstr. Tek. Infrastruktur dan Sains, vol. 1, no. 1, pp. 10–21, 2022.

G. Hariyanto, H. Ashad, and A. Alifuddin, “Pengaruh Modulus Kehalusan Terhadap Kuat Tekan Beton,” J. Tek. Sipil MACCA, vol. 6, no. 3, pp. 193–202, 2021.

L. B. Said and H. St Maryam, “Analisis Penurunan Umur Rencana Jalan Akibat Volume Kendaraan dan Kelebihan Muatan Pada Ruas Jalan Jend. Ahmad Yani Kota Parepare,” J. Flyover, vol. 1, no. 2, pp. 38–47, 2021.

M. T. Hasan, L. B. Said, and A. Alifuddin, “Stabilisasi Subgrade dengan Kapur Tohor dan Aktivator untuk Struktur Perkerasan Jalan,” J. Tek. Sipil MACCA, vol. 6, no. 3, pp. 175–185, 2021.

I. A. A. Angreni, S. A. Adisasmita, M. I. Ramli, and S. Hamid, “Evaluating the Road Damage of Flexible Pavement Using Digital Image,” Int. J. Integr. Eng., vol. 10, no. 2, 2018.

E. Mardiani and F. A. Ramadhan, “Design Information System Sales of Nuts and Bolts at PT. Catur Naga Steelindo,” SITEKIN J. Sains, Teknol. dan Ind., vol. 20, no. 2, pp. 729–735, 2023.




DOI: https://doi.org/10.35308/jts-utu.v10i1.8056

Refbacks

  • There are currently no refbacks.


Copyright (c) 2024 Muhammad Said, Lambang Basri Said, Mukhtar Thahir Syarkawi

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.