SIMULASI MONTE CARLO UNTUK MENENTUKAN KEANDALAN PADA BAGIAN BOILER DI PEMBANGKIT LISTRIK BERBASIS BATUBARA

Iing Pamungkas, Heri Tri Irawan, Arhami Arhami, Muhammad Dirhamsyah

Abstract


PT. PLN (Persero) currently uses a lot of coal-based power plants or Steam Power Plants (PLTU) in carrying out its operational activities. Aceh Province has a PLTU located in Nagan Raya Regency and is owned by PT. PLN (Persero). The Nagan Raya power plant has two generating units with an installed capacity of 2x110 Megawatts. The highest frequency of interference or damage experienced by the boiler section and this is very influential on the Nagan Raya PLTU production system. Performance evaluation in terms of reliability is needed to minimize interference or damage. The purpose of this study is to determine the level of reliability using Monte Carlo simulations on each important component of the boiler section. Monte Carlo simulations will be used to predict the time between failure or time to failure (TTF) and time to repair (TTR) so that the level of reliability can be predicted in the future. Monte Carlo simulations basically produce uniformly distributed random numbers (0.1) and then convert them into non-uniform distributions using the inverse transformation method. Monte Carlo simulation results on eight critical components in the boiler section obtained time to failure (TTF) obtained were 260 hours to 1312 hours with a reliability value of 30% to 42%. While the time to repair (TTR) is 1,57 hours to 2,26 hours with a reliability value of 22% to 41%.

Keywords


Boiler; Reliability; Monte Carlo Simulation

Full Text:

PDF

References


E. L. Putri, A. Bahauddin dan P. F. Ferdinant, “Usulan Jadwal Perawatan Pada Mesin Electric Arc Furnace 5 dengan Simulasi Monte Carlo,” Jurnal Teknik Industri, vol. 1, no. 4, pp. 352-257, Des. 2013.

S. J. Kamat and M. W. Riley, “Determination reliability using Monte Carlo simulation”. IEEE Transactions on Reliability 24 (1): 73-75, 1975.

S. H. Eko dan B. Untung, “Analisa Keandalan Sistem Bahan Bakar Motor Induk Pada Kapal Motor Leuser,” Jurnal Kapal, vol. 5, no. 4, pp. 123-135, Juni 2008.

E. C. Ebeling, An Introduction To Reliability And Maintainability Engineering, International Ed. Singapore: McGraw Hill, 1997.

D. Priyanta, Rekayasa Keandalan dan Perawatan, Surabaya, Indonesia: Institut Teknologi Sepuluh November, 2000.

S. Sinulingga, Metodologi Penelitian, Medan, Indonesia: USU Press, 2011.




DOI: https://doi.org/10.35308/jopt.v4i2.1505

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Jurnal Optimalisasi



JOPT: Jurnal Optimalisasi indexed by: